Packet Tracer – Basic Device Configuration

Topology

Objectives

• Complete the network documentation.
• Perform basic device configurations on a router and a switch.
• Verify connectivity and troubleshoot any issues.

Scenario

• Your network manager is impressed with your performance in your job as a LAN technician. She would like you to demonstrate your ability to configure a router that connects two LANs. Your tasks include configuring basic settings on a router and a switch using the Cisco IOS. You will also configure IPv6 addresses on network devices and hosts. You will then verify the configurations by testing end-to-end connectivity. You goal is to establish connectivity between all devices.
  
  Note: The VLAN1 interface on will not be reachable over IPv6.
  
  In this activity you will configure the router, switch, and the PC hosts.
  
  Note: Packet Tracer will not score some configured values, however these values are required to accomplish full connectivity in the network.

Requirements

• Provide the missing information in the Addressing Table.


• Name the router and the second switch . You will not be able to access the switch.


• Use cisco as the user EXEC password for all lines.


• Use class as the encrypted privileged EXEC password.


• Encrypt all plaintext passwords.


• Configure an appropriate banner.


• Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.


• Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.


• The hosts are partially configured. Complete the IPv4 addressing, and fully configure the IPv6 addresses according to the Addressing Table.


• Document interfaces with descriptions, including the VLAN 1 interface.


• Save your configurations.


• Verify connectivity between all devices. All devices should be able to ping all other devices with IPv4 and IPv6.


• Troubleshoot and document any issues.


• Implement the solutions necessary to enable and verify full end-to-end connectivity.
  
  Note: Click Check Results button to see your progress. Click the Reset Activity button to generate a new set of requirements.